Subaru LEGACY 2006 Manual page 3942

asieps_tobira.book 15 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CAUTION:
• Be sure to install so that the pad return
spring faces the input side of the direction of
brake rotor rotation, as shown in the figure.
• Correctly install the pad return spring to the
supporting surface of the pad clip as shown in
the figure.
• If the pad return spring is deformed or dam-
aged, replace the brake pad.
(1) Pad return spring
(2) Supporting surface of pad clip
(3) Direction of brake rotor rotation
5) Install the caliper body to the support.
Tightening torque:
27 N·m (2.8 kgf-m, 19.9 ft-lb)
Front Brake Pad
(1)
(2)
(3)
BR-00483
BR-15
C: INSPECTION
1. 16-INCH TYPE
Check the pad thickness A.
A
Standard
Pad thickness mm
(in)
Wear limit
NOTE:
• Always replace the pads of both sides as a set.
• Replace pad clips if they are twisted or worn.
• Replace the pad if there is oil or grease on it.
2. 17-INCH TYPE
Check the pad thickness A.
A
Standard
Pad thickness mm (in)
Wear limit
NOTE:
• Always replace the pads of both sides as a set.
• Replace the pad if there is oil or grease on it.
BRAKE
BR-00360
11 (0.43)
1.5 (0.059)
BR-00360
11 (0.43)
1.5 (0.059)