Front Brake Pad - Subaru LEGACY 2006 Manual

asieps_tobira.book 13 ページ ２００９年１０月２６日 月曜日 午前９時１６分

2. Front Brake Pad

A: REMOVAL
1. 16-INCH TYPE
1) Lift-up the vehicle, and remove the front wheels.
2) Remove the caliper bolt.
3) Raise the caliper body and support it.
NOTE:
Do not disconnect the brake hose from the caliper
body.
4) Remove the pad.
NOTE:
If the brake pad is difficult to remove, proceed as
follows:
(1) Remove the caliper body from support.
(2) Remove the support.
(3) Place the support between wooden blocks
in the vise.
(1) Support
(2) Wooden block
Front Brake Pad
BR-00339
BR-00012
(1)
(2)
BR-00013
BR-13
(4) Attach a rod of less than 12 mm (0.47 in) di-
ameter to the shaded area of the brake pad,
and strike the rod with a hammer to drive brake
pad out.
2. 17-INCH TYPE
Refer to 16-inch type. <Ref. to BR-13, 16-INCH
TYPE, REMOVAL, Front Brake Pad.>
B: INSTALLATION
1. 16-INCH TYPE
1) Apply a thin coat of Molykote M7439 (Part No.
003602001) to the pad clip.
2) Apply a thin coat of Molykote AS880N (Part No.
K0779YA010) to the contact surface between the
pad and pad inner shim.
BRAKE
BR-00014
BR-00340
BR-00238