Subaru LEGACY 2006 Manual page 3296

asieps_tobira.book 70 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
C: DISASSEMBLY
1) Take out the transfer clutch by lightly tapping the
end of the rear drive shaft.
NOTE:
Be careful not to damage the oil seal of the exten-
sion case.
(B)
(A) Extension case
(B) Transfer clutch
2) Remove the transfer clutch pipe while being
careful not to deform the pipe.
(A) Extension case
(B) Transfer clutch pipe
3) Remove the dust cover from extension case.
4) Remove the oil seal from the extension case.
Extension Case
D: ASSEMBLY
1) Press-fit the new oil seal using ST and the press.
ST 498057300
2) Press-fit the dust cover.
3) Install the transfer clutch pipe to the extension
case while being careful not to deform the pipe.
(A)
AT-00119
4) Install the transfer clutch assembly to the case.
NOTE:
• Be careful not to damage the seal ring.
• Press-fit the clutch assembly to the bottom of the
(A)
bearing shoulder completely.
(B)
AT-00120
E: INSPECTION
• Blow with compressed air to make sure the
transfer pipe and extension case routes are not
clogged or leaking.
• Inspect the extension end play, and adjust it to
within the standard value.
<Ref. to 4AT-75, ADJUSTMENT, Transfer Clutch.>
4AT-70
INSTALLER
(A) Extension case
(B) Transfer pipe
(A)
(B)
(A) Transfer clutch
(B) Extension case
(A)
(B)
AT-00120
AT-00125