Subaru LEGACY 2006 Manual page 3697

asieps_tobira.book 20 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CONTROL SYSTEMS
B: INSTALLATION
1) Set the select lever to vehicle body.
2) Tighten the four bolts to install the select lever to
vehicle body, and then connect the connector.
(1) Temporarily tighten the bolt A.
(2) Tighten the bolt B.
(3) Tighten the bolt A.
(4) Tighten the bolts C and D.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
C
A
3) Install the harness clips to the bracket.
4) Install the center console. <Ref. to EI-54, IN-
STALLATION, Center Console.>
5) Install the console box. <Ref. to EI-52, INSTAL-
LATION, Console Box.>
6) Shift the select lever to "N" range.
7) Lift up the vehicle.
8) Shift the range select lever to the "N" range.
9) Secure the cable to the bracket. <Ref. to CS-25,
INSTALLATION, Select Cable.>
10) Adjust the select cable position. <Ref. to CS-
27, ADJUSTMENT, Select Cable.>
11) After the completion of adjustment, confirm that
the select lever operates properly at all range posi-
tions.
12) Install the heat shield cover.
Select Lever
13) Install the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO)-8, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-10, INSTALLA-
TION, Muffler.>
• DOHC turbo model
<Ref. to EX(H4DOTC)-12, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-13, IN-
STALLATION, Muffler.>
• DOHC 3.0 L model
<Ref. to EX(H6DO)-7, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H6DO)-9, INSTALLA-
TION, Muffler.>
14) Inspect the following items. When a malfunc-
tion is found in the inspection, adjust the select ca-
ble and inhibitor switch.
B
NOTE:
Inhibitor switch for 5AT model is not adjustable.
<Ref. to CS-27, ADJUSTMENT, Select Cable.>
D
<Ref. to 4AT-46, ADJUSTMENT, Inhibitor Switch.>
(1) Engine starts when the select lever is in "P"
CS-00520
and "N" range, but not in other ranges.
(2) Back-up light illuminates when the select le-
ver is in the "R" range, but not in other ranges.
(3) Select lever and indicator positions are
matched.
C: DISASSEMBLY
1) Shift the select lever to "N" range.
2) Remove the indicator light.
CS-00518
3) Remove the grip.
4) Remove the indicator assembly.
CS-20
CS-00521
CS-00522