Subaru LEGACY 2006 Manual page 4207

asieps_tobira.book 61 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
AC:DTC C0044 AT COMMUNICATION
DTC DETECTING CONDITION:
No CAN signal from TCM.
TROUBLE SYMPTOM:
• ABS does not operate.
• VDC does not operate.
Step
1 CHECK LAN SYSTEM.
Perform the diagnosis for LAN system. <Ref. to
LAN(diag)-25, OPERATION, Read Diagnostic
Trouble Code (DTC).>
2 CHECK POOR CONTACT IN CONNECTORS. Is there poor contact in TCM
3 CHECK TCM.
4 CHECK THE VDCCM&H/U.
1) Connect all the connectors.
2) Erase the memory.
3) Perform the Inspection Mode.
4) Read the DTC.
5 CHECK OTHER DTC DETECTION.
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)
Check
Is there any fault in LAN sys-
tem?
connector?
Is the TCM normal?
Is the same DTC displayed?
Is any other DTC displayed?
VDC(diag)-61
Yes No
Perform the diag- Go to step 2.
nosis according to
DTC for LAN sys-
tem.
Repair the con- Go to step 3.
nector.
Go to step 4.
Replace the TCM.
<Ref. to 4AT-62,
Transmission Con-
trol Module
(TCM).> <Ref. to
5AT-56, Transmis-
sion Control Mod-
ule (TCM).>
Replace the Go to step 5.
VDCCM&H/U.
Perform the diag- It results from a
nosis according to temporary noise
DTC. interference.