Subaru LEGACY 2006 Manual page 4033

bp06usen601.fm 29 ページ ２０１０年５月２７日 木曜日 午後３時６分
26) Apply a coat of grease to the sliding surface of
sleeve and seating surface of spring, and then in-
sert the sleeve into steering body.
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw. Then install
on the steering body.
(1)
(1) Sleeve
(2) Spring
(3) Adjusting screw
27) Tighten the adjusting screw to the specified
torque, then loosen it.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
28) Tighten the adjusting screw to the specified
torque, then loosen it 20°.
Tightening torque:
3.9 N·m (0.4 kgf-m, 2.9 ft-lb)
29) Remove the tie-rod.
30) Adjust the turning resistance of gearbox so that
it is within specification using adjusting screw.
<Ref. to PS-36, TURNING RESISTANCE OF
GEARBOX, INSPECTION, Steering Gearbox.>
31) Apply liquid gasket to lock nut and install it into
adjusting screw. While holding the adjusting screw
with wrench, tighten the lock nut using ST.
Liquid gasket:
THREE BOND 1102 or equivalent
ST 926230000 SPANNER
Tightening torque (lock nut):
25 N·m (2.5 kgf-m, 18.1 ft-lb)
NOTE:
Hold the adjusting screw with a wrench to prevent it
from turning while tightening lock nut.
32) Extend the rack approx. 40 mm (1.57 in) from
steering body.
Steering Gearbox
(3)
(2)
PS-00167
PS-29
POWER ASSISTED SYSTEM (POWER STEERING)
33) Install the tie-rod and new lock washer into
rack.
Tightening torque:
90 N·m (9.1 kgf-m, 65.8 ft-lb)
(2)
(1)
(1) Lock washer
(2) Approx. 40 mm (1.57 in)
34) Bend the lock washer and crimp it.
CAUTION:
Be careful not to scratch the rack when crimp-
ing lock washer.
(1) Lock washer
PS-00439
PS-00093