Subaru LEGACY 2006 Manual page 3958

asieps_tobira.book 16 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DRIVE SHAFT SYSTEM
D: ASSEMBLY
1) Assemble the front hub unit bearing. <Ref. to
DS-18, ASSEMBLY, Front Hub Unit Bearing.>
2) Place the disc cover between housing and front
hub unit, and tighten the four bolts.
Tightening torque:
65 N·m (6.6 kgf-m, 47.9 ft-lb)
(A) Housing
CAUTION:
• Do not get closer the tool which charged
magnetism to magnetic encoder.
• Be careful not to damage the magnetic en-
coder.
(1)
(1) Magnetic encoder
(2) Front hub unit bearing
Front Axle
E: INSPECTION
1) Moving the front tire up and down by hand,
check there is no backlash in bearing, and check
the wheel rotates smoothly.
(A)
2) Inspect the lean of axis direction using a dial
gauge. Replace the bearing if the load range ex-
ceeds the limitation.
DS-00231
Service limit:
(2)
DS-00250
DS-16
Maximum: 0.05 mm (0.0020 in)
DS-00061
DS-00062