Subaru LEGACY 2006 Manual page 3947

asieps_tobira.book 23 ページ ２００９年１０月２６日 月曜日 午前９時１６分
8) While depressing the brake pedal, tighten a new
axle nut (olive color) to the specified torque and
lock it securely.
Tightening torque:
220 N·m (22.4 kgf-m, 162 ft-lb)
CAUTION:
• Install the wheel after installation of axle nut.
Failure to follow this rule may damage the
wheel bearing.
• Be sure to tighten axle nut to specified
torque. Do not overtighten it as this may dam-
age the wheel bearing.
9) After tightening axle nut, lock it securely.
10) Fill the transmission gear oil. (MT model)
11) Fill the differential gear oil. (AT model)
C: DISASSEMBLY
1) Place alignment marks on the shaft and outer race.
2) Remove the PTJ boot band and boot.
CAUTION:
Be careful not to damage the boot.
3) Remove the snap ring from PTJ outer race.
Front Drive Shaft
4) Remove the PTJ outer race from shaft assem-
bly.
5) Wipe off grease.
CAUTION:
The grease is a special type of grease. Do not
mix with other grease.
6) Place alignment marks on the roller kit and trun-
nion.
DS-00106
7) Remove the roller kit from trunnion.
CAUTION:
Be careful with the roller kit position.
8) Place alignment marks on the trunnion and
shaft.
DS-00107
DS-00108
DS-23
DRIVE SHAFT SYSTEM
DS-00109
DS-00110