Subaru LEGACY 2006 Manual page 3355

asieps_tobira.book 85 ページ ２００９年１０月２６日 月曜日 午前９時１６分
C: DISASSEMBLY
1) Remove the crimped part of the lock nut, and
then remove the lock nut while holding the rear
spline part of the shaft using ST1 and ST2. Pull out
the drive pinion collar.
ST1 18667AA010 HOLDER
ST2 499787700 WRENCH
ST3 499787500 ADAPTER
ST3
2) Remove the O-ring.
3) Separate the roller bearing and outer race from
shaft using a press.
(A) Outer race
4) Separate the front roller bearing from shaft using
a press and ST.
ST 498517000 REPLACER
(A) Front roller bearing
Drive Pinion Shaft Assembly
ST2
ST1
AT-00197
(A)
AT-00198
(A)
ST
AT-00199
5AT-85
AUTOMATIC TRANSMISSION
D: ASSEMBLY
1) Measure the dimension "A" of drive pinion shaft.
ST 398643600 GAUGE
2) Using a press, press-fit the new roller bearing
into the specified position.
NOTE:
If excessive force is applied to roller bearing, the
roller bearing will not turn easily.
(A) Drive pinion shaft
(B) Roller bearing
3) After fitting a new O-ring to the shaft, attach the
drive pinion collar to the shaft.
4) Install the lock washer to drive pinion shaft in the
proper direction.
A
AT-00200
(A)
(B)
AT-00201