Subaru LEGACY 2006 Manual page 3816

asieps_tobira.book 13 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. Front ABS Wheel Speed Sen-
sor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the ABS wheel speed sensor con-
nector located next to the front strut mounting
house in the engine compartment.
3) Separate the sensor connector and vehicle se-
curing clip. Apply force in the direction of (2) to un-
lock the claw, and then slide the connector in the
direction of (3). Pull out the connector to the tire
side from grommet hole.
CAUTION:
Clip would break when removing the clip with-
out separating sensor connector and clip.
(1)
(2)
(1) Claw
4) Remove the sensor harness bracket.
(1)
(2)
(1) To the front ABS wheel speed sensor connector
(2) Sensor harness bracket
5) Remove the bolts which secure the sensor har-
ness to the front strut.
Front ABS Wheel Speed Sensor
(3)
ABS00434
ABS00386
ABS-13
6) Remove the front ABS wheel speed sensor from
housing.
CAUTION:
• Be careful not to damage the sensor.
• Do not apply excessive force to the sensor
harness.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Sensor:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Bracket:
33 N·m (3.3 kgf-m, 24 ft-lb)
CAUTION:
Be careful not to damage the sensor.
NOTE:
• Check the identification (mark) on the harness to
make sure there is no warpage. (RH: K1 (White),
LH: K2 (Yellow))
• Check if the harness is not pulled and does not
come in contact with the suspension or body during
steering wheel effort.
ABS
ABS00387