Subaru LEGACY 2006 Manual page 3777

asieps_tobira.book 58 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
8) Select one to three shims in the following table
for the value determined as described above, and
take the shim(s) which thickness is closest to the
said value.
Drive pinion shim
Part number
32295AA031
32295AA041
32295AA051
32295AA061
32295AA071
32295AA081
32295AA091
32295AA101
9) Install the differential assembly. <Ref. to 5MT-
66, INSTALLATION, Front Differential Assembly.>
10) Set the transmission main shaft assembly for
single range and drive pinion assembly in the install
location. (When doing so, there will be no clear-
ance between the two when moved all the way to
the front). Inspect a suitable 1st-2nd, 3rd-4th and
5th shifter fork so that the coupling sleeve and re-
verse driven gear are positioned in the center of the
synchronizing mechanism. <Ref. to 5MT-63, IN-
SPECTION, Drive Pinion Shaft Assembly.>
11) Install the transmission case. <Ref. to 5MT-49,
INSTALLATION, Transmission Case.>
12) Install the transfer case together with the exten-
sion case assembly. <Ref. to 5MT-36, INSTALLA-
TION, Transfer Case and Extension Case
Assembly.>
13) Install the manual transmission assembly to the
vehicle. <Ref. to 5MT-24, Manual Transmission
Assembly.>
Drive Pinion Shaft Assembly
C: DISASSEMBLY
NOTE:
Attach a cloth to the end of driven shaft (on the fric-
tional side of the thrust needle bearing) to prevent
damage during disassembly or reassembly.
Thickness mm (in)
1) Flatten the lock nut tab. Remove the lock nut
0.150 (0.0059) with ST1, ST2 and ST3.
0.175 (0.0069) ST1 899884100
ST2 498427100
0.200 (0.0079)
ST3 899988608
0.225 (0.0089)
0.250 (0.0098)
0.275 (0.0108)
0.300 (0.0118)
0.500 (0.0197)
2) Draw out the drive pinion from driven shaft.
Remove the differential bevel gear sleeve, adjust-
ing washer No. 1, adjusting washer No. 2, thrust
bearing, needle bearing and drive pinion collar.
5MT-58
HOLDER
STOPPER
SOCKET WRENCH (27)
ST1
ST2
ST3
( E )
( F )
( G )
( H )
( C )
( D )
(A) Differential bevel gear sleeve
(B) Washer No. 1 (25 × 37.5 × t)
(C) Thrust bearing (25 × 37.5 × 3)
(D) Washer No. 2 (25 × 37.5 × 4)
(E) Needle bearing (25 × 30 × 20)
(F) Drive pinion collar
(G) Needle bearing (30 × 37 × 23)
(H) Thrust bearing (33 × 50 × 3)
MT-00244
( A )
( B )
MT-00245