Subaru LEGACY 2006 Manual page 3539

asieps_tobira.book 46 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Step
1 CHECK DTC.
2 CHECK BODY INTEGRATED UNIT.
1) Turn the ignition switch to OFF.
2) Connect the Subaru Select Monitor to the
data link connector.
3) Turn the ignition switch to ON. (engine
OFF)
4) Turn the Subaru Select Monitor switch to
ON.
5) Depress the brake pedal.
6) Read the data of brake pedal switch using
Subaru Select Monitor. <Ref. to LAN(diag)-12,
OPERATION, Subaru Select Monitor.>
3 CHECK TCM.
Read the data of brake pedal switch using
Subaru Select Monitor. <Ref. to 5AT(diag)-16,
OPERATION, Subaru Select Monitor.>
4 CHECK BODY INTEGRATED UNIT INPUT
SIGNAL.
1) Disconnect the connector from body inte-
grated unit.
2) Depress the brake pedal.
3) Measure the voltage between body inte-
grated unit connector and chassis ground.
Connector & terminal
(B281) No. 23 (+) — Chassis ground (–):
5 CHECK HARNESS CONNECTOR BETWEEN
BODY INTEGRATED UNIT AND STOP LIGHT
SWITCH.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from stop light
switch.
3) Measure the resistance of harness
between body integrated unit and stop light
switch.
Connector & terminal
(B281) No. 23 — (B64) No. 2:
6 CHECK HARNESS CONNECTOR BETWEEN
BODY INTEGRATED UNIT AND STOP LIGHT
SWITCH.
Measure the resistance of harness between
body integrated unit connector and stop light
switch.
Connector & terminal
(B281) No. 23 — Chassis ground:
7 CHECK POOR CONTACT.
Check
Is any of following DTC dis-
played? / AT CAN Communica-
tion Circuit / Output Speed
Sensor Circuit / AT Vehicle
Speed Sensor Circuit Malfunc-
tion (Rear Wheel)
Is ON displayed?
Is ON displayed?
Is the voltage more than 10 V? Go to step 7.
Is the resistance less than 1
Ω?
Is the resistance more than 1
MΩ?
Is there poor contact in input
signal of brake switch?
5AT(diag)-46
Yes No
Perform the diag- Go to step 2.
nosis according to
DTC.
Go to step 3. Go to step 4.
A temporary poor Replace the TCM.
contact of connec- <Ref. to 5AT-56,
tor or harness may Transmission Con-
be the cause. trol Module
Check the poor (TCM).>
contact.
Go to step 5.
Go to step 6. Repair the open
circuit of harness
between body inte-
grated unit and
stop light switch.
Go to step 7.
Repair the short
circuit of harness
between body inte-
grated unit and
stop light switch.
Repair the poor Check the body
contact. integrated unit.