Subaru LEGACY 2006 Manual page 3930

asieps_tobira.book 21 ページ ２００９年１０月２６日 月曜日 午前９時１６分
5. Rear Brake Pad
A: REMOVAL
1) Lift-up the vehicle, and then remove the rear
wheels.
2) Remove the caliper bolt.
3) Raise the caliper body and support it.
NOTE:
Do not disconnect the brake hose from the caliper
body.
4) Remove the pad.
NOTE:
If it is difficult to remove the brake pad, use the
same procedure as front disc brake pad.
<Ref. to BR-13, REMOVAL, Front Brake Pad.>
Rear Brake Pad
B: INSTALLATION
1) Apply a thin coat of Molykote M7439 (Part No.
003602001) to the pad clip.
2) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to the contact surface between the
BR-00344
pad and shim.
3) Install the pad to support.
4) Install the caliper body to the support.
Tightening torque:
Solid disc brake model
27 N·m (2.8 kgf-m, 19.9 ft-lb)
Ventilated disc brake model
37 N·m (3.7 kgf-m, 27.2 ft-lb)
C: INSPECTION
Check the pad thickness A.
BR-00032
Type of disc rotor
Pad thickness
mm (in) Wear limit
NOTE:
• Always replace the pads of both sides as a set.
• Replace pad clips if they are twisted or worn.
• A wear indicator is installed on the inner disc
brake pad. If the pad is worn to the limit, the end of
wear indicator contacts disc rotor, and a squeaking
sound is heard as the wheel rotates. If the sound is
heard, replace the pad.
• Replace the pad if there is oil or grease on it.
BR-21
BRAKE
BR-00345
A
BR-00016
Solid Ventilated
Standard 9.0 (0.35) 9.0 (0.35)
1.5 (0.059) 1.5 (0.059)