Subaru LEGACY 2006 Manual page 3682

asieps_tobira.book 17 ページ ２００９年１０月２６日 月曜日 午前９時１６分
3) Separate the piston and piston spring.
NOTE:
The illustration below is for a non-turbo model.
D: ASSEMBLY
NOTE:
When assembling, apply operating oil on all parts
while preforming work.
Recommended brake fluid:
FMVSS No. 116, fresh DOT3 or 4 brake fluid
1) Install the piston spring onto the piston.
NOTE:
The illustration below is for a non-turbo model.
2) Insert the piston into the operating cylinder.
3) Attach the push rod to the boot.
4) Attach the boot and push rod to the operating
cylinder.
Operating Cylinder
E: INSPECTION
1) Check the operating cylinder for damage. If op-
erating cylinder is damaged, replace it.
2) Check the operating cylinder for fluid leakage or
damage on the boot. If any leakage or damage is
found, replace the operating cylinder.
CL-00459
CL-00459
CL-00457
CL-17
CLUTCH SYSTEM