Subaru LEGACY 2006 Manual page 3368

asieps_tobira.book 98 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
8) Install the leaf spring.
(A)
B'
B'
(A)
(A) Leaf spring
9) Install the retaining plate.
10) Install the snap ring of the reverse brake.
11) Perform the clearance check of reverse brake.
(1) Measure the clearance between retainer
plate and snap ring using thickness gauge.
Standard value:
0.7 — 1.1 mm (0.028 — 0.043 in)
AT Main Case
B
B
AT-01999
AT-01998
AT-02372
5AT-98
(2) If it is out of specification, select a suitable
retainer plate from the following table and as-
semble it.
Retainer plate
Part number
31567AB100
31567AB170
31567AB180
31567AB190
31567AB200
12) Install the direct clutch assembly.
13) Install the high & low reverse clutch assembly.
14) Install the thrust needle bearing of the high &
low reverse clutch.
Thickness mm (in)
4.2 (0.165)
4.4 (0.173)
4.6 (0.181)
4.8 (0.189)
5.0 (0.197)
AT-01997
AT-01996
AT-01995