Subaru LEGACY 2006 Manual page 3902

asieps_tobira.book 36 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DIFFERENTIALS
3) Install the selected pinion height adjusting wash-
er on drive pinion, and press the rear bearing cone
into position with ST.
ST 398177700 INSTALLER
ST
4) Insert the drive pinion into the differential carrier,
and install the preselected bearing preload adjust-
ing collar and washer.
(A)
(B)
(C)
(A) Drive pinion
(B) Bearing preload adjusting collar
(C) Bearing preload adjusting washer
(D) Differential carrier
5) Press-fit the front bearing cone into case with
ST1, ST2 and ST3.
ST1 398507703 DUMMY COLLAR
ST2 399780104 WEIGHT
ST3 899580100 INSTALLER
ST3
ST1
ST2
Rear Differential (T-type)
6) Insert the collar, then press-fit the pilot bearing
with ST1 and ST2.
ST1 399780104
ST2 899580100
DI-00085
7) Fit a new oil seal with ST.
NOTE:
• Press-fit until the oil seal end comes 1 mm (0.04
in) inward from end of carrier.
• Apply grease to the oil seal lips.
ST 498447120
(D)
DI-00086
8) Press-fit the companion flange with ST1 and
ST2.
NOTE:
Be careful not to damage the bearing.
ST1 899874100
ST2 399780104
DI-00087
9) Apply seal material on the drive pinion shaft
thread and new self-locking nut seat.
SEAL MATERIAL
THREE BOND 1324 (Part No. 004403042) or
equivalent
DI-36
WEIGHT
INSTALLER
ST2
ST1
DI-00088
INSTALLER
ST
DI-00089
INSTALLER
WEIGHT
ST1
ST2
DI-00090