Subaru LEGACY 2006 Manual page 3269

asieps_tobira.book 120 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
19) Install the needle bearing, and then secure with
the snap ring.
(A)
(A) Needle bearing
(B) Snap ring
20) Install the one-way clutch and one-way clutch
inner race, then secure with the snap ring.
21) Set the inner race. Make sure that the clutch
locks in the clockwise direction and rotates freely in
the counterclockwise direction.
(A)
(A) Locked
(B) Free
3. 2-4 BRAKE
1) Apply ATF to the D-ring, and then install it to the
2-4 brake piston.
2) Install 2-4 brake piston to 2-4 brake piston re-
tainer.
( A )
(A) 2-4 brake piston
(B) 2-4 brake piston retainer
AT Main Case
4. ONE-WAY CLUTCH INNER RACE
1) Install the needle bearing to inner race using ST
and a press.
(B)
ST 398497701
AT-00268
2) Apply vaseline to the groove of the inner race
and seal ring.
3) Install two seal rings to the one-way clutch inner
race.
(B)
AT-00282
5. ONE-WAY CLUTCH OUTER RACE
1) Install the needle bearing, and then secure with
the snap ring.
( B )
AT-00288
2) Install the one-way clutch, and then secure with
the snap ring.
4AT-120
SEAT
ST
(A)
(B)
(A) One-way clutch inner race
(B) Seal ring
(A)
(A) Needle bearing
(B) Snap ring
AT-00299
AT-00298
(B)
AT-00268