Subaru LEGACY 2006 Manual page 3780

asieps_tobira.book 61 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4) Install the 1st driven gear, inner baulk ring, syn-
chro cone, outer baulk ring, gear & hub assembly
onto driven shaft. (Turbo model)
(A)
(C)
(A) 1st driven gear
(B) Inner baulk ring
(C) Synchro cone
(D) Outer baulk ring
NOTE:
• Take care to install the gear & hub assembly in
proper direction.
• Align the baulk ring and gear & hub assembly
with the key groove.
5) Install the 2nd driven gear bushing onto the driv-
en shaft using ST1, ST2 and a press.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Attach a cloth to the end of the driven shaft to
prevent damage.
• When press fitting, align the oil holes of the shaft
and bush.
ST1 499277200 INSTALLER
ST2 499587000 INSTALLER
Drive Pinion Shaft Assembly
(D)
(B)
MT-00992
ST1
ST2
MT-00253
5MT-61
MANUAL TRANSMISSION AND DIFFERENTIAL
6) Install the 2nd driven gear, inner baulk ring, syn-
chro cone and outer baulk ring, and insert them
onto driven shaft.
(C)
(A) 2nd driven gear
(B) Inner baulk ring
(C) Synchro cone
(D) Outer baulk ring
7) After installing key on driven shaft, install the
3rd-4th driven gear using an ST and a press.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Align the groove in baulk ring with the insert.
ST 499277200 INSTALLER
8) Install a set of roller bearings onto the driven
shaft using the ST and a press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
(D) (A)
(B)
MT-01223
ST
MT-00255
ST
MT-00256