Subaru LEGACY 2006 Manual page 4084

asieps_tobira.book 16 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Rear Shock Absorber
REAR SUSPENSION
C: DISASSEMBLY
Refer to "Front Strut" for disassembly procedure.
<Ref. to FS-21, DISASSEMBLY, Front Strut.>
D: ASSEMBLY
Refer to "Front Strut" for installation procedures.
<Ref. to FS-21, ASSEMBLY, Front Strut.>
E: INSPECTION
Refer to "Front Strut" for inspection procedures.
<Ref. to FS-22, INSPECTION, Front Strut.>
F: DISPOSAL
CAUTION:
• Before handling the shock absorber, be sure
to wear goggles to protect eyes from gas, oil
and cutting powder.
• Do not disassemble the shock absorber or
place it into a fire.
• Drill a hole into shock absorbers in case of
discarding shock absorbers filled with gas.
1) Place the shock absorber on a level surface with
the piston rod fully expanded.
2) Make a hole into the specified position 30 mm
(1.18 in) deep using a drill with 2 — 3 mm (0.08 —
0.12 in) diameter.
(1)
RS-00135
(1) 40 mm (1.57 in)
RS-16