Toyota Tundra 2005 Service - Repair - Maintenance page 2876

SUPPLEMENTAL RESTRAINT SYSTEM
H23881
- SIDE AIRBAG SENSOR ASSEMBLY
INSTALLATION
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
NOTICE:
z
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new ones.
z
Never reuse the side airbag sensor assembly in-
volved in a collision when the airbag has deployed.
z
If the side airbag sensor assembly center has been
dropped, or there are any cracks, dents or other de-
fects in the case, bracket or connector, replace it with
a new one.
z
When installing the side airbag sensor assembly, be
careful that the SRS wiring does not interfere with
other parts and that it is not pinched between other
parts.
z
After installing, shake the side airbag sensor assem-
bly to check that there is no looseness.
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH
(a) Install the side airbag sensor assembly LH with the 3
bolts.
Torque: 17.5 N·m (179 kgf·cm, 13 ft·lbf)
(b) Connect the connector to the side airbag sensor assem-
bly LH.
2. INSTALL FRONT SEAT OUTER BELT RETRACTOR
(SEE PAGE BO-252
3. INSTALL CENTER PILLAR LOWER GARNISH
(SEE PAGE BO-138
4. INSTALL FRONT SEAT OUTER BELT FLOOR AN-
CHOR (SEE PAGE
5. INSTALL REAR DOOR SCUFF PLATE
(SEE PAGE BO-138
6. INSTALL FRONT DOOR SCUFF PLATE
(SEE PAGE BO-138
7. CONNECT CABLE TO NEGATIVE BATTERY TERMI-
NAL
8. INSPECT SRS WARNING LIGHT (SEE PAGE
Author :
)
)
BO-138 )
)
)
Date :
RS-109
RS12W-01
DI-1859 )
4524