Toyota Tundra 2005 Service - Repair - Maintenance page 3146

: 4 Clips
(b)
(b)
(b)
BODY
11. REMOVE REAR DOOR BELT MOULDING
(a) Apply protective tape to the outer surface, as shown in the
illustration, to prevent the vehicle surface from being
scratched.
(b) Using a moulding remover, remove the rear door belt
moulding.
H23259
12. REMOVE REAR DOOR WINDOW FRAME REAR LOW-
ER
Remove the bolt, nut and rear door window frame rear lower,
as shown in the illustration.
HINT:
Remove the rear door window frame rear lower through the ser-
vice hole.
H23266
13. REMOVE REAR DOOR POWER WINDOW REGULA-
(c)
TOR
(a) Disconnect the connector.
(b) Remove the 5 bolts.
(c) Loosen the bolt, and remove the rear door power window
(b)
regulator.
(b)
HINT:
Remove the rear door power window regulator through the ser-
vice hole.
H23537
(d) Remove the 3 screws and power window regulator motor
from the rear door power window regulator.
14. REMOVE REAR DOOR LOCK
(a) Disconnect the 2 control cables from the clamp.
(b) Remove the clamp.
(c) Disconnect the connector.
(d) Using a torx® socket wrench, remove the 3 torx® screws.
Torx® socket wrench:
T30 (Part No. 09042-00010 or locally manufactured
tool)
(e) Remove the rear door lock.
HINT:
Remove the rear door lock through the service hole.
15. REMOVE REAR DOOR OUTSIDE HANDLE
Remove the 2 bolts and rear door outside handle.
H23262
- REAR DOOR (Double Cab)
Author :
BO-33
Date :
4804