Toyota Tundra 2005 Service - Repair - Maintenance page 2410

Hide thumbs Also See for Tundra 2005:

Table of Contents

PROPELLER SHAFT

SPIDER BEARING

Sufficiently raise the part indicated by "A" so that it does not

come into contact with the bearing.

Remove the bearing on the opposite side using the same pro-

Remove the bearing on the opposite side using the same pro-

SPIDER BEARING

PLACE MATCHMARKS ON SHAFT AND YOKE

REMOVE SNAP RING

Using a brass bar and hammer, slightly tap in the bearing

4WD rear propeller shaft:

Using 2 screwdrivers, remove the 4 snap rings from the

2WD and 4WD front propeller shaft:

Using needle nose pliers, remove the 4 snap rings from

the grooves.

REMOVE SPIDER BEARING

Using SST, push out the bearing from the flange yoke.

Clamp the bearing outer race in a vise and tap off the

flange with a hammer.

Install the 2 removed bearing outer races to the spider,

and clamp them in a vise.

Using SST, push out the bearing from the sleeve yoke.

Clamp the outer bearing race in a vise and tap off the yoke

with a hammer.