Toyota Tundra 2005 Service - Repair - Maintenance page 2720

SR-42
Matchmarks
Matchmarks
STEERING - STEERING COLUMN (Double Cab)
INSTALLATION
NOTICE:
When replacing the steering angle sensor, drive the vehicle
straight ahead at a speed of 6.5 mph (10.5 km/h) or more.
Accordingly, zero point calibration of the steering angle
sensor is performed.
HINT:
If the steering angle sensor zero point calibration is not per-
formed, its value will be fixed. Check after driving the vehicle
straight ahead at a speed of 6.5 mph (10.5 km/h) or more (See
page DI-1568
1. INSTALL NO. 2 INTERMEDIATE SHAFT ASSEMBLY
(a) Align the matchmark on the No. 2 intermediate shaft as-
sembly with the one on the control valve shaft.
(b) Install the bolt.
Torque: 35 N·m (360 kgf·cm, 26 ft·lbf)
F17897
2. CONNECT NO. 2 UNIVERSAL JOINT ASSEMBLY
(a) Insert the column hole cover No. 2.
(b) Align the matchmarks on the column assembly and No.
2 universal joint assembly.
(c) Install the bolt.
Torque: 35 N·m (360 kgf·cm, 26 ft·lbf)
3. INSTALL STEERING COLUMN ASSEMBLY WITH NO.
2 UNIVERSAL JOINT ASSEMBLY
(a) Install the column assembly with the No. 2 universal joint
F17913
assembly.
(b) Install the 4 steering column set nuts.
Torque: 26 N·m (260 kgf·cm, 19 ft·lbf)
(c) Connect the connectors.
4. CONNECT TRANSMISSION CONTROL CABLE AS-
SEMBLY
Connect the cable assembly to the shift lever assembly.
).
Author :
SR1KR-01
Date :
4368