Toyota Tundra 2005 Service - Repair - Maintenance page 3330

BO-216
4 Claws
BODY - REAR SEAT (LH)
(c) Remove the reclining connecting wire of the RH side
edge.
(d) Remove the 4 bolts and the seatback assembly.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
8. REMOVE ARMREST
H05326
9. REMOVE SEATBACK COVER
(a) Using a screwdriver, disengage the 4 claws and remove
the rear seat shoulder belt cover.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 4 headrest supports.
(c) Disengage the hooks, and remove the seatback frame
from the seatback cover with pad.
(d) Remove the seatback cover from the seatback pad.
H23464
(e) Remove the hog rings and seatback cover.
HINT:
At the time of reassembly, take as much care as possible to
minimize wrinkles when installing hog rings.
10. REMOVE REAR SEATBACK BOARD
Using a clip remover, remove the 6 clips and seatback board.
H23465
Author : Date :
4987