Toyota Tundra 2005 Service - Repair - Maintenance page 3144

Clip
8 Clips
BODY - REAR DOOR (Double Cab)
DISASSEMBLY
HINT:
A bolt without a torque specification is shown in the standard
bolt chart (see page
1. REMOVE DOOR INSIDE BEZEL
(a) Using a screwdriver, open the cover.
HINT:
Tape the screwdriver tip before use.
(b) Remove the screw.
(c) Using a screwdriver, remove the door inside bezel, as
shown in the illustration.
HINT:
Tape the screwdriver tip before use.
2. REMOVE COURTESY LIGHT
3. REMOVE REAR ARMREST BASE PANEL UPPER
(a) Remove the rear ash receptacle.
H04751
(b) Using a screwdriver, remove the rear armrest base panel
upper together with the power window switch.
HINT:
Tape the screwdriver tip before use.
(c) Disconnect the connector.
(d) Remove the power window switch from the rear armrest
base panel upper.
H16659
4. REMOVE REAR DOOR TRIM PANEL
(a) Using a screwdriver, remove the cap.
HINT:
Tape the screwdriver tip before use.
(b) Remove the screw and 2 clips.
(c) Insert a screwdriver between the rear door trim panel and
door panel to remove the rear door trim panel.
HINT:
Tape the screwdriver tip before use.
H23257
(d) Pull the rear door trim panel upward to remove the rear
door trim panel.
(e) Remove the rear door weatherstrip inner from the rear
door trim panel.
5. REMOVE SPEAKER
(a) Disconnect the connector.
(b) Remove the 3 screws and speaker.
SS-2 ).
Author : Date :
BO-31
BO4PV-02
4802