Toyota Tundra 2005 Service - Repair - Maintenance page 2451

SUSPENSION AND AXLE
SST
R13368
SST
4.5 ± 0.3 mm
(0.177 ± 0.012 in.)
R13374
SST
FA1083
FA1084
Less than
5 mm (0.20 in.)
R13338
− FRONT DIFFERENTIAL REAR OIL SEAL
(b) Using SST and the companion flange, install the rear
bearing, then remove the companion flange.
SST 09950−30012 (09951−03010, 09953−03010,
09954−03010, 09955−03030, 09956−03020)
8. INSTALL OIL SEAL
(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST 09554−22010
Oil seal drive in depth: 4.5 ± 0.3 mm (0.177 ± 0.012 in.)
9. INSTALL COMPANION FLANGE
(a) Place the companion flange on the drive pinion.
(b) Coat the threads of a new nut with hypoid gear oil.
(c) Using SST to hold the flange, torque the nut.
SST 09330−00021
Torque: 108 N·m (1,100 kgf·cm, 80 ft·lbf)
10. ADJUST DRIVE PINION PRELOAD (See page
SA−48)
11. STAKE DRIVE PINION NUT
12. INSTALL FRONT PROPELLER SHAFT (See page
PR−15)
13. FILL DIFFERENTIAL WITH HYPOID GEAR OIL
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Oil type: Hypoid gear oil API GL−5
Recommended oil viscosity: SAE 75W−90
Capacity: 1.15 liters (1.22 US qts, 1.01 Imp. qts)
14. INSTALL ENGINE UNDER COVER
SA−37