Toyota Tundra 2005 Service - Repair - Maintenance page 2628

BR−52
B
Z03659
F07755
A
Adjusting Bolt
Lock Nut
C
F05418
F07757
F08787
BRAKE − REAR DRUM BRAKE
INSTALLATION
Installation is in the reverse order of removal (See page
BR−48).
NOTICE:
Apply lithium soap base glycol grease and high tempera-
ture grease to the parts indicated by the arrows
(See page BR−47).
1. ADJUST BELLCRANK
(a) Lightly pull the bellcrank in direction A until there is no
slack at part B.
(b) In this condition, turn the adjusting bolt so that dimension
C will be 0.4 to 0.8 mm (0.016 to 0.031 in.).
(c) Lock the adjusting bolt with the lock nut.
(d) Connect the parking brake cable to the parking brake bell-
crank and install the pin and clip.
(e) Install the 2 tension springs.
2. CHECK OPERATION OF AUTOMATIC ADJUSTING
MECHANISM
(a) Move the parking brake lever of the front shoe back and
forth. Check that the adjuster turns.
If the adjuster does not turn, check for incorrect installation of
the rear brakes.
(b) Adjust the adjuster length as short as possible.
(c) Install the brake drum.
(d) Pull the parking brake lever all the way up or depress the
parking brake pedal all the way until a clicking sound can
no longer be heard.
BR10R−02