Toyota Tundra 2005 Service - Repair - Maintenance page 3105

Timing chart of registration mode:
Garage Door
PRESSED
Opener Switch
RELEASED
ENTER
Registration
Mode
EXIT
ON
Indicator
Operation
OFF
ON
Original
Transmitter
OFF
BODY ELECTRICAL -
20 sec.
(b) Erase transmitter codes in the garage door opener clear
mode.
HINT:
D
All 3 registered transmitter codes must be erased at the
same time.
D
If the switches are released within 10 seconds after the
transmitter codes have been erased, the garage door
opener will enter registration mode.
Indicator
D
If the switches are held for 10 seconds or more after the
I27622
transmitter codes have been erased, default codes will be
set to the 3 switches of the garage door opener. Using
these default codes, you can check operation of the ga-
rage door opener can be checked using a tester.
Press and hold the left and right switch of the garage door
opener for 20 seconds. The indicator will begin to flash at
a cycle of 5.6 Hz. Releasing the switches will end clear
mode.
GARAGE DOOR OPENER SYSTEM (Double Cab)
Indicator flashes
at a cycle of 1 Hz
Author :
BE-205
Indicator flashes
at a cycle of 5.6 Hz
I03487
Date :
4762