Toyota Tundra 2005 Service - Repair - Maintenance page 3265

BODY - FRONT SEAT (Separate Type: Power Adjuster)
12. INSTALL ARMREST ASSEMBLY
(a) Install the spacer to the armrest assembly.
(b) Install the armrest assembly, armrest lock plate and arm-
rest spacer with the bolt.
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
HINT:
Install the armrest lock plate as shown in the illustration.
(c) Install the armrest cap.
13. INSTALL POWER SWITCH
H24316
Install the power switch with the 3 screws.
14. INSTALL LUMBAR SWITCH
Install the lumbar switch with the 2 screws to the seat cushion
outer shield.
15. INSTALL FRONT SEAT INNER BELT
(a) Install the front seat inner belt with the nut.
Torque: 42 N·m (430 kgf·cm, 32 ft·lbf)
(b) Connect the connectors and wire harness clamps.
16. INSTALL SEAT CUSHION LOWER SHIELD, SEAT
CUSHION OUTER SHIELD AND SEAT CUSHION IN-
NER SHIELD
(a) Assemble the seat cushion lower shield and seat cushion
outer shield with the screw.
(b) Perform the same procedure on the other side.
(c) Connect the lumbar switch connector to the seat cushion
outer shield, and install the seat cushion lower shield, out-
er shield and inner shield.
H24315
(d) Install the 2 screws to the seat cushion lower shield.
(e) Install the screw to the seat cushion inner shield.
H24314
(f) Install the 2 screws to the seat cushion outer shield.
H24313
Author : Date :
BO-151
4922