Toyota Tundra 2005 Service - Repair - Maintenance page 2711

®
Torx Screw
Airbag Connectors
Correct
Matchmarks
STEERING
REMOVAL
1.
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.
2.
NOTICE:
If the airbag connector is disconnected with the ignition
switch in the ON or ACC position, DTCs will be recorded.
(a)
Screw Case
(b)
(c)
(d)
HINT:
Loosen each screw until the groove along the screw circumfer-
ence is caught on the screw case.
F19881
(e)
CAUTION:
L
L
NOTICE:
When removing the wheel pad, take care not to pull the air-
bag wire harness.
Wrong
F17904
3.
(a)
(b)
(c)
(d)
SST
F14451
- STEERING COLUMN (Double Cab)
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
REMOVE STEERING WHEEL PAD
Place the front wheels facing straight ahead.
Remove the steering wheel lower No. 2 cover.
Remove the steering wheel lower No. 3 cover.
Using a torx® socket wrench, loosen the 2 torx® screws.
Pull out the wheel pad from the steering wheel and dis-
connect the airbag connectors and horn terminal.
When storing the wheel pad, keep the upper surface
of the pad facing upward.
Never disassemble the wheel pad.
REMOVE STEERING WHEEL
Remove the steering wheel set nut.
Put matchmarks on the steering wheel and main shaft as-
sembly.
Using SST, remove the wheel.
SST 09950- 50013 (09951- 05010, 09952- 05010,
09953-05020, 09954-05021)
Disconnect the connector.
Author :
SR-33
SR1KN-01
Date :
4359