Toyota Tundra 2005 Service - Repair - Maintenance page 2419

Front
B
Rear
D
C
R13288
R13289
SUSPENSION AND AXLE
FRONT WHEEL ALIGNMENT
INSPECTION
1. MEASURE VEHICLE HEIGHT (See page SS−59)
Measuring points:
A: Ground clearance of the front drive shaft center
B: Ground clearance of the front adjusting cam bolt center
A
C: Ground clearance of the rear axle shaft center
D: Ground clearance of the leaf spring front side bushing
center
Vehicle height:
Front: A − B
Rear: C − D
NOTICE:
Before inspecting the wheel alignment, adjust the vehicle
height to the specified value.
If the vehicle height is not the specified value, try to adjust it by
pushing down on or lifting the body.
F01718
2. INSTALL CAMBER−CASTER−KINGPIN GAUGE OR
POSITION VEHICLE ON WHEEL ALIGNMENT TES-
TER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER, CASTER AND STEERING AXIS
INCLINATION (See page SS−59)
If the steering axis inclination is not within the specified value,
after the camber and caster have been correctly adjusted, re-
check the steering knuckle and front wheel for bearing or loose-
Z03382
ness.
4. ADJUST CAMBER AND CASTER
(a) Loosen the front and/or rear adjusting cam set bolts.
(b) Adjust the camber and caster by front and/or rear adjust-
ing cams (See adjustment chart).
HINT:
Try to adjust the camber and caster to the center of the specified
values.
R13227
− FRONT WHEEL ALIGNMENT
SA−5
SA1FZ−06