Toyota Tundra 2005 Service - Repair - Maintenance page 2871

RS-104
SUPPLEMENTAL RESTRAINT SYSTEM - FRONT AIRBAG SENSOR
INSTALLATION
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
NOTICE:
z
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new ones.
z
Never reuse the front airbag sensor involved in a col-
lision when the airbag has deployed.
H23879
z
If the front airbag sensor center has been dropped, or
there are any cracks, dents or other defects in the
case, bracket or connector, replace it with a new one.
z
When installing the front airbag sensor center, be
careful that the SRS wiring does not interfere with
other parts and that it is not pinched between other
parts.
z
After installing, shake the front airbag sensor to
check that there is no looseness.
1. INSTALL FRONT AIRBAG SENSOR LH
(a) Install the front airbag sensor LH with the 2 nuts.
Torque: 17.5 N·m (179 kgf·cm, 13 ft·lbf)
(b) Connect the front airbag sensor connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMI-
NAL
3. INSPECT SRS WARNING LIGHT (SEE PAGE
Author : Date :
RS12R-01
DI-1859 )
4519