Toyota Tundra 2005 Service - Repair - Maintenance page 2857

RS-90
SUPPLEMENTAL RESTRAINT SYSTEM
SST
Curtain Shied Airbag Assembly
SST
Battery
10 m (33 ft) or more
(e) Install the SST.
After connecting the SST below to each other, connect
them to the curtain shield airbag assembly.
SST
H23225
(f) Place the tires.
(1)
(2)
Tires
(5 or More)
NOTICE:
Do not place the SST connector under the tire because it
could be damaged.
H23226
(3)
CAUTION:
Make sure that the wire harness is tight. Looseness in the
wire harness results in the tires coming free due to the
shock when the airbag is deployed.
H23917
(g) Install the SST.
Connect the SST connector.
SST
NOTICE:
To avoid damaging the SST connector and wire harness,
do not lock the secondary lock of the twin lock. Also, se-
cure some slack for the SST wire harness inside the tire.
(h) Deploy the airbag.
(1)
H23227
(2)
- CURTAIN SHIELD AIRBAG ASSEMBLY
09082-00802, 09082-00760
Place at least 2 tires under the tire which the curtain
shield airbag assembly is tied to.
Place at least 2 tires over the tire which the curtain
shield airbag assembly is tied to. The top tire should
have the disc wheel installed.
Tie the tires together with 2 wire harness.
09082-00700
Connect the red clip of the SST to the battery posi-
tive (+) terminal and the black clip of the SST to the
battery negative (-) terminal.
Check that no one is within a 10 m (33 ft) radius of
the tire which the shield airbag assembly is tied to.
Author : Date :
4505