Toyota Tundra 2005 Service - Repair - Maintenance page 3138

Hide thumbs Also See for Tundra 2005:

Table of Contents

REMOVE FRONT DOOR WINDOW FRAME MOULD-

Remove the 6 screws.

Using a screwdriver or clip remover, remove the front door

window frame moulding upper.

Tape the screwdriver tip before use.

REMOVE FRONT DOOR BELT MOULDING

Apply protective tape to the outer surface, as shown in the

illustration, to prevent the vehicle surface from being

Using a moulding remover, remove the front door belt

REMOVE FRONT DOOR FRAME FRONT LOWER

Remove the 2 bolts, nut and front door frame front lower,

as shown in the illustration.

Remove the front door glass run No. 2 from the front door

frame front lower.

REMOVE FRONT DOOR FRAME REAR LOWER

Remove the bolt, nut and front door frame rear lower, as shown

in the illustration.

Remove the front door frame rear lower through the service

REMOVE FRONT DOOR POWER WINDOW REGULA-

Disconnect the connector.

Remove the 5 bolts.

Loosen the bolt, and remove the front door power window

Remove the front door power window regulator through the ser-

FRONT DOOR (Double Cab)