Toyota Tundra 2005 Service - Repair - Maintenance page 3214

BO-100
BODY - SLIDING ROOF
REMOVAL
HINT:
A bolt without a torque specification is shown in the standard
bolt chart (see page
1. REMOVE ROOF HEADLINING (See page
2. REMOVE SLIDING ROOF GLASS ASSEMBLY
(a) Using a torx wrench, remove the 4 screws.
(b) Pull the glass upward to remove it.
3. REMOVE DRIVE GEAR
NOTICE:
Remove the drive gear with the sliding roof fully closed.
(a) Disconnect the connector.
(b) Remove the 2 bolts and drive gear.
(c) Remove the 2 screws and drive gear bracket.
H16774
4. REMOVE SLIDING ROOF HOUSING
(a) Disconnect the 4 drain hoses from the housing.
(b) Disengage the wire harness clamps.
(c) Remove the 8 bolts, 2 nuts and sliding roof housing.
Torque: 5.5 N·m (56 kgf·cm, 49 in.·lbf)
SS-2 ).
Author : Date :
BO4Q9-01
BO-133 )
H23513
4871