Marking
BODY
-
FRONT SEAT (Bench Type)
REASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:
A bolt without a torque specification is shown in the standard
bolt chart (See page
1.
INSTALL BELT WARNING OCCUPANT DETECTION
SENSOR
Peel the coated paper off the back of the new sensor. Attach the
sensor along with the marking on the pad surface as shown in
the illustration.
H24310
2.
INSTALL SEAT CUSHION COVER
Install the seat cushion cover with the hog rings.
HINT:
When installing the hog rings, take as much care as possible to
prevent wrinkles.
H24722
3.
INSTALL SEAT CUSHION FRAME
Install the seat cushion frame to the seat cushion pad and cover
with the hog rings.
HINT:
When installing the hog rings, take as much care as possible to
prevent wrinkles.
H24721
4.
INSTALL SEAT TRACK HANDLE RH
(a)
Install the seat track handle RH with the nut.
(b)
Install the spring.
(c)
Connect the seat track control cable.
(d)
Tighten the adjusting nuts.
HINT:
When tightening the nuts, hold one and tighten the other.
H24305
SS-2
).
Author :
Date :
BO-171
BO4ST-03
4942