Toyota Tundra 2005 Service - Repair - Maintenance page 2543

SST
SST
LH
#
SUSPENSION AND AXLE
Matchmarks
F16146
F16239
F16240
Matchmarks
F16241
W01873
− REAR DIFFERENTIAL CARRIER (w/ LSD)
14. REMOVE RING GEAR
(a) Place matchmarks on the ring gear and differential case.
(b) Remove the 12 ring gear set bolts.
(c) Using a plastic hammer, tap on the ring gear to separate
it from the differential case.
15. CHECK DIFFERENTIAL CASE RUNOUT
(a) Install the differential case in the differential carrier (See
page SA−133).
(b) Using a dial indicator, measure the differential case run-
out.
Maximum case runout: 0.04 mm (0.0016 in.)
(c) Remove the differential case.
16. REMOVE SIDE BEARINGS
Using SST, remove the 2 side bearings from the differential
case.
SST 09950−40011 (09951−04010, 09952−04010,
09953−04020, 09954−04010, 09955−04061,
09957−04010, 09958−04011),
09950−60010 (09951−00480)
HINT:
Fix the claws of SST to the notch in the differential case.
17. DISASSEMBLE DIFFERENTIAL CASE
(a) Place matchmarks on the LH and RH cases.
(b) Remove the 8 bolts uniformly, a little at a time.
(c) Using a plastic hammer, separate the LH and RH cases.
18. REMOVE THESE PARTS FROM DIFFERENTIAL LH
AND RH CASES:
HINT:
Keep the disassembled parts in order.
(a) Remove these parts from the LH case.
(1) Remove the side gear.
(2) Remove the 4 side gear thrust washers.
(3) Remove the 3 clutch plates.
SA−129