Toyota Tundra 2005 Service - Repair - Maintenance page 3352

BO-238
7 Clips
2 Clips
BODY - SEAT BELT PRETENSIONER
(4) Using a screwdriver, remove the quarter trim.
HINT:
Tape the screwdriver tip before use.
(f) Remove the retractor of the front seat outer belt.
CAUTION:
Never disassemble the front seat outer belt.
NOTICE:
When removing the retractor of the front seat outer belt,
take care not to pull the seat belt pretensioner wire har-
H11156
ness.
(1) Disconnect the pretensioner connector as shown in
the illustration.
(2) Remove the 2 bolts and retractor of the front seat
outer belt.
3. Access cab:
REMOVE FRONT SEAT OUTER BELT
(a) Remove the 4 screws and front door scuff plate.
(b) Remove the 3 screws and rear door scuff plate.
(c) Remove the bolt and front seat outer belt floor anchor.
H11400
(d) Remove the front seat outer belt shoulder anchor.
(1) Using a screwdriver, remove the cap.
HINT:
Tape the screwdriver tip before use.
(2) Remove the bolt and front seat outer belt shoulder
anchor.
(e) Remove the roof side rail garnish.
(1) Using a screwdriver, remove the caps.
HINT:
H11394
Tape the screwdriver tip before use.
(2) Using a torx® driver, remove the 2 torx® screws and
assist grip.
Torx® driver:
T30 (Part No. 09041-00030 or locally manufactured
tool)
(3) Using a screwdriver, remove the roof side rail gar-
nish.
HINT:
Tape the screwdriver tip before use.
(f) Remove the front door rear scuff plate and cover.
(1) Remove the clip and cover.
(2) Remove the clip and front door rear scuff plate.
(g) Remove the retractor of the front seat outer belt.
CAUTION:
H11159
Never disassemble the front seat outer belt.
Author : Date :
5009