Toyota Tundra 2005 Service - Repair - Maintenance page 3237

BODY
INSTALLATION
1.
(a)
Hinge
(b)
NOTICE:
Be careful not to drop the tail gate.
H09454
2.
(a)
(b)
(c)
3.
H20699
Using a torx® socket wrench (T40), install the 2 tail gate lock
strikers with the 4 screws.
4.
Install the tail gate handle assembly with the 2 bolts.
5.
(a)
H09452
(b)
6.
Using a torx® socket wrench (T30), install the service hole cover
with the 8 screws.
7.
H20698
- TAIL GATE
INSTALL TAIL GATE
Using a torx® socket wrench (T40), install the tail gate
hinges to the tail gate with the 4 screws.
Torque: 17 N·m (178 kgf·cm, 13 ft·lbf)
Install the tail gate to the body with the 2 bolts.
Torque: 17 N·m (178 kgf·cm, 13 ft·lbf)
INSTALL TAIL GATE CABLE
Install the tail gate cable and gate side shaft to the tail
gate.
Torque: 27 N·m (275 kgf·cm, 20 ft·lbf)
Install the tail gate cable and deck side shaft to the body.
Torque: 27 N·m (275 kgf·cm, 20 ft·lbf)
Use the same procedures described above to the other
side.
INSTALL TAIL GATE LOCK STRIKER
Torque: 13 N·m (133 kgf·cm, 10 ft·lbf)
INSTALL TAIL GATE HANDLE ASSEMBLY
Torque: 5.5 N·m (56 kgf·cm, 49 in.·lbf)
INSTALL TAIL GATE LOCK
Using a torx® socket wrench (T40), install the 2 tail gate
locks with the 4 screws.
Torque: 12.5 N·m (128 kgf·cm, 9 ft·lbf)
Connect one end of the tail gate lock link to the tail gate
lock and another end to the tail gate handle assembly.
INSTALL SERVICE HOLE COVER
INSTALL TAIL GATE PROTECTOR (See page
BO-68 )
Author :
BO-123
BO0J9-08
Date :
4894