Toyota Tundra 2005 Service - Repair - Maintenance page 2585

BRAKE − BRAKE FLUID
HINT:
S
Pump operating sound can be heard.
S
Brake fluid is pumped out automatically.
S
To protect the solenoids, the hand−held tester turns OFF
automatically 2 sec. after every solenoid has been turned
ON.
(7) Repeat (6) until the air is completely bled out of
brake fluid.
(8) When air does not come out with brake fluid, tighten
the bleeder plug.
Torque: (Bleeder plug) 11 N·m (110 kgf·cm, 8 ft·lbf)
(9) Repeat the above procedures for each wheel to
bleed the air out of the brake line .
(10) Turn the ignition switch off.
(11) Turn the ignition switch on again.
(12) Clear DTCs (see page
(f) Check fluid level in reservoir.
(1) Turn the ignition switch off and depress the brake
pedal more than 20 times.
HINT:
When pressure in the accumulator is released, reaction force
becomes light and stroke becomes longer.
(2) Add brake fluid up to the MAX line of the reservoir
tank.
Fluid: SAE J1703 or FMVSS No.116 DOT3
F19536
HINT:
When the ignition switch is turned to the ON position, brake fluid
is sent to the accumulator. The brake fluid level drops by 5 mm
when the ignition switch is off, which is normal.
DI−1397 or DI−1497).
BR−9