Toyota Tundra 2005 Service - Repair - Maintenance page 2636

BR−60
Valve Side
REASSEMBLY
1.
(a)
(b)
HINT:
S
F08892
S
2.
Install the lock nut, plate washer and shackle No. 1 to shackle
No. 2, then install the upper nut.
3.
Shackle Side
(a)
BR0070
(b)
4.
Install the load sensing spring to the load sensing valve with the
clip.
5.
(a)
(b)
BRAKE − LOAD SENSING PROPORTIONING AND BY−PASS
VALVE (LSP & BV)
ASSEMBLE LOAD SENSING SPRING
Install the load sensing valve boot and load sensing
spring boot.
Install the 2 collars and 4 bushings.
Apply lithium soap−base glycol grease to all rubbing
areas.
Do not mistake the valve side for the shackle side of the
load sensing spring.
INSTALL SHACKLE NO. 1 AND NO. 2
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
INSTALL LOAD SENSING SPRING TO SHACKLE
NO. 1
Install the load sensing spring and 2 plate washers to
shackle No. 1.
Install the bolt, washer and nut.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
INSTALL LOAD SENSING SPRING TO VALVE BODY
INSTALL VALVE BRACKET
Install the set plate to the load sensing valve through the
valve bracket and temporarily tighten the 2 washers and
2 nuts.
Install the load sensing spring assembly, 2 plate washers,
bolt, washer and nut.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
BR10T−03