Toyota Tundra 2005 Service - Repair - Maintenance page 2467

Proper Contact
Washer
Thickness mm (in.)
1.69 − 1.71 (0.0665 − 0.0673)
1.72 − 1.74 (0.0677 − 0.0685)
1.75 − 1.77 (0.0689 − 0.0697)
1.78 − 1.80 (0.0701 − 0.0709)
1.81 − 1.83 (0.0713 − 0.0720)
1.84 − 1.86 (0.0724 − 0.0732)
1.87 − 1.89 (0.0736 − 0.0744)
1.90 − 1.92 (0.0748 − 0.0756)
SUSPENSION AND AXLE
Heel Contact
Toe Contact
If the teeth are not contacting properly, use the following table
to select a proper washer for correction.
FA2008
Washer thickness:
Thickness
1.93 − 1.95 (0.0760 − 0.0768)
1.96 − 1.98 (0.0772 − 0.0780)
1.99 − 2.01 (0.0783 − 0.0791)
2.02 − 2.04 (0.0795 − 0.0803)
2.05 − 2.07 (0.0807 − 0.0815)
2.08 − 2.10 (0.0819 − 0.0827)
2.11 − 2.13 (0.0831 − 0.0839)
2.14 − 2.16 (0.0843 − 0.0850)
14. REMOVE COMPANION FLANGE AND OIL SLINGER
(See page SA−41)
15. REMOVE REAR BEARING (See page SA−41)
16. INSTALL NEW BEARING SPACER, REAR BEARING
AND OIL SLINGER
(a) Install a new bearing spacer and place the rear bearing
and oil slinger.
− FRONT DIFFERENTIAL CARRIER
Select an adjusting washer that will bring the
drive pinion closer to the ring gear.
Select an adjusting washer that will shift the
drive pinion away from the ring gear.
mm (in.)
Face Contact
Flank Contact
Thickness mm (in.)
2.17 − 2.19 (0.0854 − 0.0862)
2.20 − 2.22 (0.0866 − 0.0874)
2.23 − 2.25 (0.0878 − 0.0886)
2.26 − 2.28 (0.0890 − 0.0898)
2.29 − 2.31 (0.0902 − 0.0909)
2.32 − 2.34 (0.0913 − 0.0921)
−
−
SA−53
Z00699