Toyota Tundra 2005 Service - Repair - Maintenance page 3031

BE-122
2
1
5
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
BODY ELECTRICAL
I24634
1
2
I24765
1
2
I24766
3
5
1 2
N14863
Driver Side J/B
I11896
- POWER SLIDE BACK WINDOW SYSTEM (Except
Double Cab)
INSPECTION
1. INSPECT POWER SLIDE BACK WINDOW SWITCH
CONTINUITY
Switch Position
OPEN
OFF
CLOSE
If the continuity is not as specified, replace the switch.
2. CHECK POWER SLIDE BACK WINDOW MOTOR PTC
THERMISTOR OPERATION
(a) Disconnect the connector from the window motor.
(b) Connect the positive (+) lead from the ammeter to termi-
nal 1 of the motor connector and the negative (-) lead to
the negative terminal of the battery.
(c) Connect the positive (+) lead from the battery to terminal
2 of the motor connector, and slide the window to the fully
closed position.
(d) Continue to apply voltage and check that the current
changes to less than 1 A in 4 to 90 seconds.
(e) Disconnect the leads from the terminals.
(f) Approximately 60 seconds later, connect the positive (+)
lead from the battery to terminal 1 and the negative (-)
lead to terminal 2, and check that the window begins to
slide open.
If operation is not as specified, replace the regulator and motor
assembly.
3. INSPECT POWER RELAY CONTINUITY
Tester Connection
3 - 5
3 - 5
If the continuity is not as specified, replace the relay.
4. CHECK INTEGRATION RELAY
Remove the integration relay from the driver side J/B, and
check the voltage or continuity of each terminal on the driver
side J/B side (see page
Author :
Tester Connection
1 - 3, 2 - 6
2 - 3, 2 - 6
1 - 6, 2 - 3
Specified Condition
No continuity
Continuity
(When battery voltage is applied to terminals 1 and 2)
BE-128 ).
Date :
BE2LJ-01
Specified Condition
Continuity
Continuity
Continuity
4679