Toyota Tundra 2005 Service - Repair - Maintenance page 2549

RH Case
A2
SST
B2
SUSPENSION AND AXLE
2. RH side:
SELECT ADJUSTING SHIM(S)
(a) Measure the differential case dimension "A2", as shown
in the illustration.
(b) Install the thrust washers (face their fine side to the side
gear) and clutch plates on the side gear.
HINT:
Install the new thrust washer (Mark N) instead of the thrust
washers (Mark A − M) to the differential case side.
F16256
(c) Using SST to press down the thrust washers and clutch
plates with about pressure of 10 kgf (22 lbf), measure di-
mension "B2", as shown in the illustration.
Thrust
SST
Washer
(d) Referring to the following selection table on the next
Mark N
page, select the proper adjusting shim(s).
Adjusting shim thickness =
A2 − B2 − 16.175 mm (0.63681 in.)
F16257
− REAR DIFFERENTIAL CARRIER (w/ LSD)
Adjusting shim mark and thickness mm (in.)
A
B
C
D
E
09649−17010
SA−135
0.15 (0.0059)
0.20 (0.0079)
0.25 (0.0098)
0.30 (0.0118)
0.35 (0.0138)