Toyota Tundra 2005 Service - Repair - Maintenance page 3187

BODY - WINDSHIELD
12. REMOVE COWL TOP VENTILATOR LOUVER
(a) Remove the hood to cowl top seal.
(b) Using a clip remover, remove the 6 clips.
(c) Remove the 8 screws and cowl top ventilator louver.
13. REMOVE FRONT PART OF ROOF SIDE RAIL WEATH-
ERSTRIP LH AND RH
Using SST, pull off the roof side rail weatherstrip from front end.
SST 09806-30010
H16708
14. REMOVE WINDSHIELD OUTSIDE MOULDING
(a) Remove the 4 screws and windshield outside moulding.
(b) Perform the same procedure on the other side.
H11396
15. w/ Standed cab, Access cab:
REMOVE WINDSHIELD OUTSIDE UPPER MOULDING
(a) Using a knife, cut off the moulding as shown in the illustra-
tion.
NOTICE:
Do not damage the body with the knife.
(b) Remove the remaining moulding.
H11170
16. w/Double cab:
REMOVE WINDSHIELD OUTSIDE UPPER MOULDING
Using a knife, cut off the moulding as shown in the illustration.
NOTICE:
Do not damage the body with the knife.
H05613
17. REMOVE WINDSHIELD GLASS
(a) Push piano wire through between the body and glass
from the interior.
(b) Tie both wire ends to wooden blocks or similar objects.
HINT:
Apply protective tape to the outer surface to keep the surface
from being scratched.
BO5232
Author : Date :
BO-73
4844