Toyota Tundra 2005 Service - Repair - Maintenance page 3362

BO-248
BODY
(h) Dispose of the front seat outer belt (with seat belt preten-
sioner).
CAUTION:
z
The front seat outer belt is very hot when the seat belt
pretensioner is activated. Leave it alone for at least 30
minutes after activation.
z
Use gloves and safety glasses when handling a front
seat outer belt with activated seat belt pretensioner.
z
Always wash your hands with water after completing
the operation.
z
Do not apply water to a front seat outer belt with acti-
vated seat belt pretensioner.
HINT:
When scrapping a vehicle, activate the seat belt pretensioner
and scrap the vehicle with activated front seat outer belt still
installed.
2. ACTIVATION WHEN DISPOSING OF FRONT SEAT
OUTER BELT ONLY
NOTICE:
z
When disposing of the front seat outer belt (with seat
belt pretensioner) only, never use the customer's ve-
hicle to activate the seat belt pretensioner.
z
Be sure to follow the procedure given on the next
page when activating the seat belt pretensioner.
(a) Disconnected the negative (-) terminal cable from the
Negative
battery.
Battery
Terminal
HINT:
Have a battery ready as the power source when activating the
seat belt pretensioner.
NOTICE:
If the cable is disconnected from the negative battery termi-
nal, the preset AM and FM stations stored in memory are
erased. Be sure to make note of them before disconnecting
BO4111
the cable.
CAUTION:
Work must be started at least 90 seconds after the ignition
switch is turned to the LOCK position and the cable is dis-
connected from the negative (-) battery terminal.
(The SRS is equipped with a back-up power source. If work
is started within 90 seconds of disconnecting the cable
from the negative (-) battery terminal, the SRS may deploy.)
(b) Remove the front seat outer belt (see page
HINT:
Cut the belt near the seat belt retractor.
- SEAT BELT PRETENSIONER
Author :
BO-229 ).
Date :
5019