Toyota Tundra 2005 Service - Repair - Maintenance page 3010

HINT:
In the initial status, "8" is displayed.
(c) The displayed number increases +1 every time the E/M switch is pressed. Referring to the map, check
the number for the area where the vehicle will be used and set the zone number.
(d) Leave it untouched for several seconds after setting and check that the compass display shows an
azimuthal direction (N, NE, E, SE, S, SW, W, or NW) or "VAR".
7. CALIBRATION SETTING MODE
(a) After the set zone is displayed, if the E/M switch and MODE switch remains pressed another 5 seconds
will activate the calibration setting mode.
(b) To keep pressing the E/M switch and MODE switch for 10 seconds when outer temperature is dis-
played will also activate this mode.
(c) Drive the vehicle at a slow speed of 8 km/h (5 mph) or less in the circular direction.
(d) Driving round the circle 1 to 3 times will display the azimuthal direction on the display, completing the
calibration.
HINT:
After the calibration is completed, it is not necessary to perform the above procedures unless the magnetic
field strength is drastically changed. If this happens, the azimuthal display will be changed to "CAL".
BODY ELECTRICAL - COMPASS (Double Cab)
Author : Date :
BE-101
4658