Toyota Tundra 2005 Service - Repair - Maintenance page 3257

BODY - FRONT SEAT (Separate Type: Power Adjuster)
(e) Remove the 2 screws from the seat cushion lower shield.
(f) Disconnect the lumbar switch connector from the seat
cushion outer shield, and remove the seat cushion lower
shield, outer shield and inner shield.
H24314
(g) Remove the screw and separate the seat cushion lower
shield and seat cushion outer shield.
(h) Perform the same procedure on the other side.
4. REMOVE FRONT SEAT INNER BELT
(a) Disconnect the wire harness clamps and connectors.
(b) Remove the nut and front seat inner belt.
5. REMOVE LUMBAR SWITCH
Remove the 2 screws and lumbar switch from the seat cushion
outer shield.
H24315
6. REMOVE POWER SEAT SWITCH
Remove the 3 screws and power seat switch.
7. REMOVE ARMREST ASSEMBLY
(a) Using a screwdriver, remove the armrest cap.
(b) Remove the bolt, armrest spacer, armrest lock plate and
armrest assembly.
(c) Remove the spacer from the armrest assembly.
H24316
8. REMOVE SEATBACK COVER AND PAD
(a) Remove the hog rings from the seat frame assembly.
(b) Open the fastener.
H24317
Author : Date :
BO-143
4914