Toyota Tundra 2005 Service - Repair - Maintenance page 2466

SA−52
Thickness mm (in.)
2.00 − 2.02 (0.0787 − 0.0795)
2.03 − 2.05 (0.0799 − 0.0807)
2.06 − 2.08 (0.0811 − 0.0819)
2.09 − 2.11 (0.0823 − 0.0831)
2.12 − 2.14 (0.0835 − 0.0843)
2.15 − 2.17 (0.0846 − 0.0854)
2.18 − 2.20 (0.0858 − 0.0866)
2.21 − 2.23 (0.0870 − 0.0878)
2.24 − 2.26 (0.0882 − 0.0890)
SUSPENSION AND AXLE
Washer thickness:
Thickness
2.27 − 2.29 (0.0894 − 0.0902)
2.30 − 2.32 (0.0906 − 0.0913)
2.33 − 2.35 (0.0917 − 0.0925)
2.36 − 2.38 (0.0929 − 0.0937)
2.39 − 2.41 (0.0941 − 0.0949)
2.42 − 2.44 (0.0953 − 0.0961)
2.45 − 2.47 (0.0965 − 0.0972)
2.48 − 2.50 (0.0976 − 0.0984)
2.51 − 2.53 (0.0988 − 0.0996)
12. MEASURE TOTAL PRELOAD
Using a torque wrench, measure the preload with the teeth of
the drive pinion and ring gear in contact.
Total preload (at starting):
Drive pinion preload plus 0.4 − 0.6 N·m (4 − 6 kgf·cm,
3.5 − 5.2 in.·lbf)
13. INSPECT TOOTH CONTACT BETWEEN RING GEAR
AND DRIVE PINION
(a) Remove the 10 bolts, side bearing retainer and differen-
tial case.
(b) Coat 3 or 4 teeth at three different positions on the ring
gear with red lead primer.
(c) Install the differential case and side bearing retainer with
the 10 bolts.
Torque: 69 N·m (700 kgf·cm, 51 ft·lbf)
(d) Hold the companion flange firmly and rotate the ring gear
in both directions.
(e) Remove the 10 bolts, side bearing retainer and differen-
tial case.
R13220
(f) Inspect the tooth contact pattern.
− FRONT DIFFERENTIAL CARRIER
mm (in.) Thickness mm (in.)
2.54 − 2.56 (0.1000 − 0.1008)
2.57 − 2.59 (0.1012 − 0.1020)
2.60 − 2.62 (0.1024 − 0.1031)
2.63 − 2.65 (0.1035 − 0.1043)
2.66 − 2.68 (0.1047 − 0.1055)
2.69 − 2.71 (0.1059 − 0.1067)
2.72 − 2.74 (0.1071 − 0.1079)
2.75 − 2.77 (0.1083 − 0.1091)
2.78 − 2.80 (0.1094 − 0.1102)