Toyota Tundra 2005 Service - Repair - Maintenance page 3240

BO-126
LH: 4 Clips, RH: 3 Clips
BODY - ROOF HEADLINING
REMOVAL
HINT:
z
A bolt without a torque specification is shown in the stan-
dard bolt chart (see page
z
Tape the screwdriver tip before using it to remove the
parts.
1. Access cab:
REMOVE REAR SEAT (See page
2. REMOVE FRONT DOOR SCUFF PLATES
(a) Standard cab:
Remove the 10 screws and front door scuff plates.
(b) Access cab:
Remove the 8 screws and front door scuff plates.
3. Access cab:
REMOVE ACCESS DOOR SCUFF PLATES
Remove the 6 screws and access door scuff plates.
4. Access cab:
REMOVE FRONT DOOR REAR SCUFF PLATES
(a) Remove the 2 clips and 2 covers.
(b) Remove the 2 clips and 2 front door rear scuff plates.
5. REMOVE ASSIST GRIPS
(a) Using a screwdriver, remove the caps.
(b) Driver's side:
Using a torx® driver (T30), remove the 2 screws and assist
grip.
(c) Passenger 's side:
Using a torx® driver (T30), remove the 4 screws and 2 as-
sist grips.
H09484
6. REMOVE FRONT PILLAR GARNISH
(a) Using a screwdriver, remove the front pillar garnish.
(b) Perform the same procedure on the other side.
7. Access cab:
REMOVE FRONT SEAT OUTER BELT ANCHORS
(a) Remove the bolt and front seat outer belt floor anchor.
Torque: 42 N·m (430 kgf·cm, 31 ft·lbf)
H09485
SS-2 ).
Author : Date :
BO4T5-01
BO-203 )
4897